500-9830: POT Knife Flat Point L20 T0.63
- General use for materials up to 18mm thick
- Typical material: honeycomb board, extruded polystyreen, insulation, rubber (lower speed)
- Typical speed: 200mm/sec
500-9831: POT Knife Flat Point L27 T0.63
- General use for materials between 18-25mm
- Typical material: honeycomb board
- Typical speed: 100mm/sec
500-9832: POT Knife Flat Point L20 T1.5
- More sturdy knife (thickness of the blade is 1.5mm vs 0.63mm)
- Material up to 18mm thick
- Typical material: Corrugated plastic / Polycarbonate, Twinwall plastic
- Typical speed: 150mm/sec
500-9833: POT knife Serrated L27 T1.0
- Serrated knife
- Material up to 25mm thick
- Typical material: Soft foams
- Low speed <50mm/sec
500-9834: POT Knife Point L20 T1.0
- This knife penetrates deep into the mat/conveyor. (An extra protection mat is recommended)
- Can cut smaller details (smaller curves) than a standard pot knife (500-9830)
- Typical material: rubber
- This knife can cut ACP - Aluminium composite panels, but the edge quality is ribbed
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article