Since GoProduce Flatbed Edition version 3.1.0 (August 23, 2024) the drill hole function was implemented in the software.
For older versions of GoProduce drill holes are not possible. However there is a work around to make a hole with approximately the size of the bit:
You could make a circle in you design that is 0,1mm bigger than the diameter of your bit. This will allow GoProduce to create a inner routing path to cut out the inner circle with the bit.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article