L Series - Laser Not Working (Properly)

Possible causes:

Laser not cutting at all, only etching the material:

1. Check the Optics are clean
2. Check the Lens is fitted correctly - Dome Up
3. Check the Focus Height is set correctly
4. Check the laser power in ethos or speed are correct.

Laser Cut is intermittent - dashed lines:

1. Check the Optics are clean
2. Check the nozzle aperture is clean - not clogged up
3. Check the LED lights on the laser tube for any faults.

Laser does not Cut or Etch - No Output:

1. Check the Chiller is switched on and functioning correctly - water is flowing 
2. Check the Mechanical Shutter fully opens when Lid is Closed
3. Check the Laser interlock switch and Laser is Enabled.
4. Check the LED lights on the laser tube for any faults.