The attached document contains the procedure to install the software necessary to drive a SummaCut SE series roll-cutter, and applies to the following models:
- D60
- D60/U
- D60SE
- D60FX
- D60FXSE
- T60
- D120
- D140SE
- D160
Note: It may be necessary to upgrade the firmware of the machine to be able to use the USB port on a Windows 7/8/10 computer, as revision 16 is required for machines having firmware version MD9910.
In case of problems getting the machine up and running, it is best to contact your machine vendor as they can determine whether there is a configuration or technical issue.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article