DRIVER - SummaCut R(L) Driver Installation - GoSign

Modified on Wed, 31 Jul at 7:59 PM

This document describes how to install the software necessary to drive a SummaCut R(L) series roll-cutter, and applies to the following models:

D60R
D120R
D120RL
D140R
D140RFX
D140RL
D140RLFX
D160R
D160RL

Note:

To use GoSign to drive the cutter, the firmware revision has to be at least 039.

Click here for the procedure to upgrade the firmware.

In case of problems getting the machine up and running, it is best to contact your machine vendor as they can determine whether there is a configuration or technical issue.

Attachments (1)

pdf

Driver insta....pdf
789 KB