F Series - How to Replace a Single Edge Knife

Modified on Tue, 14 May at 4:15 PM

1. Press 'Change Tool' in Axis Control.

2. Push the button, turn the wheel, and remove the tool.

3. Hold the gliding disk firmly between your fingers. Loosen the screw. Remove the gliding disk

4. Loosen the two screws halfway.

5. Replace the knife. Push the knife to the end and tighten the screws.

6. Put the gliding disk back on and tighten the screw.

7. Insert the tool in the module, push the button, and make sure the pin drops into the slot.

8. Keep turning the wheel until it is tight.

9. Press 'Online' in Axis Control.