The attached documents contain the procedure to upgrade the firmware of the Summa SummaCut R(L) series roll cutters.
For cutters with a firmware version before revision 025, Summa Cutter Control 4 needs to be used for the upgrade.
For cutters with a firmware version from revision 25 on, Summa Cutter Control 5 can be used.
Note: Do not upgrade the firmware unless the machine faces issues or incompatibilities from some software.
WARNING: Powering down the unit too early will cause damage to the machine.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article